Difference between dry and wet firechews ontario edibles marijuana



firechews ontario edibles marijuanaAfter months of work for the future harvest, it's time to put the finish line. Careful and careful trimming (many people are more accustomed to the term "manicuring") will help you turn the cut bumps into a high-quality end product - marijuana. This process has several objectives, one of which is to make the cones aesthetically pleasing: carefully trimmed cones make a pleasant impression before the tasting process.

But it's not just for the beauty of the harvested crop that the leaves are manicured - they carry much less trich than the inflorescences. If they are left behind, the total percentage of cannabinoids in the hemp will be lower, thus reducing the quality of the crop as a whole. Worse still, the leaves tend to adsorb moisture. When dampened, they can give smoke a sharp, unpleasant flavour. On the other hand, trimmed buds maintain a stable moisture level during the cure, which gives the final product a soft taste and a pleasant, full aroma.

While some growers use the dry method, others prefer to manicure wet, not yet dried out cones. Each method has its pros and cons.

Drying begins with the cut plants being hung out for drying with flowers downwards. Large leaves are cut off in advance and small leaves growing between the flowers are not touched at this point. Thanks to the moisture retained by the green leaves, drying is slower. During this time, the biochemical processes that take place in the living plant are completed: starch and sugar decompose, chlorophyll cells are destroyed, and the absorption of nitrates and phosphates continues (albeit in minimal quantities). Eventually, the content of these substances in the final product will be minimal, which will have a positive impact on its quality.

firechews ontario edibles marijuanaHowever, this method is preferable only if the product is dried in a sufficiently dry room, under conditions close to ideal. In humid climates, such a slowdown in the drying of marijuana (untrimmed cones dry about firechews ontario twice as long as cut) is fraught with the appearance of mold or rot in the inflorescences.

Another situation in which preference is given to dry trimming is the harvesting of marijuana from large outdoors plantations, especially from partisan plantations. In this case, the first task of the grower is to quickly harvest the crop and move it to a safe place. Processing will be done later, and edibles marijuana the plants will have dried up by then. It must be said that dry trimming requires a lot of work, as drying leaves twist and lose their elasticity.

Most growers of small plants prefer wet pruning as a more natural and less time-consuming method. Some even start this process earlier by cutting back some leaves on live plants before they are cut down. At this time, many superfluous leaves can be removed simply by hand without using a special tool. Although, you will certainly need a pair of scissors to complete the job.

As soon as the plants are cut, their leaves and stems remain juicy and supple, which makes work much easier. Branches and leaf petioles can be easily bent to reach places that are difficult to reach once the inflorescences have dried. After removing large leaves, only small "sugar" leaves covered with trichomes with resin crystals will remain on the cone. They do not need to be removed under the root, only the outer part protruding from the inflorescence is cut off. The result of this treatment is neatly rounded cones, without protruding dry leaves.

This will, of course, reduce the total number of hemp florets, but the quality will be higher. The remaining cut leaves with trichomes can be further processed using them to prepare the extract.